Safety Tips Before Lighting the Pilot Light

Before attempting to light a pilot light on a Goodman furnace, there are a few safety tips that should be followed. It is important to make sure that the furnace is turned off and the power supply is disconnected. Then, it is important to wait for at least 15 minutes for the furnace to cool down before attempting to light the pilot light. In addition, it is important to check the furnace’s manual to make sure that the correct lighting procedure is followed.

Locating the Pilot Light

The pilot light is usually located near the burner on the side of the furnace. It is usually a small, blue flame. It is important to make sure that the pilot light is in the correct position before attempting to light it. If the pilot light is not in the correct position, it can be difficult to light the pilot light.

Familiarizing Yourself with the Lighting Procedure

It is important to be familiar with the lighting procedure for the Goodman furnace before attempting to light the pilot light. The lighting procedure is usually described in the furnace’s manual. It is important to follow the lighting procedure exactly as described in the manual. Some common steps in the lighting procedure include turning on the gas supply and adjusting the pilot light valve.

Turning on the Gas Supply

The first step in the lighting procedure is to turn on the gas supply. This can be done by turning on the gas valve near the furnace. It is important to make sure that the gas supply is turned on before attempting to light the pilot light. If the gas supply is not turned on, the pilot light will not be able to light.

Adjusting the Pilot Light Valve

The next step in the lighting procedure is to adjust the pilot light valve. This can be done by adjusting the knob on the valve. The knob should be turned in the direction that is indicated in the furnace’s manual. The knob should be turned until the pilot light is in the correct position.

Lighting the Pilot Light

Once the gas supply is turned on and the pilot light valve is adjusted, the pilot light can be lit. This can be done with a match or lighter. It is important to make sure that the match or lighter is held away from the pilot light. Then, the match or lighter should be held near the pilot light and the flame should be ignited.

Testing the Pilot Light

Once the pilot light is lit, it is important to make sure that the pilot light is working correctly. This can be done by testing the pilot light. The pilot light should be tested by turning the furnace on and off several times. If the pilot light stays lit, then the pilot light is working correctly.

Turning Off the Gas Supply

Once the pilot light has been lit and tested, the gas supply should be turned off. This can be done by turning off the gas valve near the furnace. It is important to make sure that the gas supply is turned off after the pilot light has been lit and tested.

Conclusion

Lighting a pilot light on a Goodman furnace is a fairly simple process. However, it is important to make sure that the correct lighting procedure is followed to ensure that the pilot light is lit correctly. It is also important to make sure that the gas supply is turned off after the pilot light has been lit and tested. Following these steps will ensure that the pilot light is lit correctly and safely.