How To Program A Key Fob Chevy Sonic

How To Program A Key Fob Chevy Sonic. Repeat step five with any additional remotes and turn the key back to the on position to end the programming sequence once you have finished. If the battery is working properly, the parking lights should flash.

Replacement Folding Keyless Entry Remote Control Key Fob
Replacement Folding Keyless Entry Remote Control Key Fob from

1) insert original key into ignition and turn to on position but without starting the car. Insert the vehicle key of the new transmitter into the key lock cylinder on the outside of the driver door and turn the key counterclockwise five times within 10 seconds. Line up the battery cover on the rear of the fob and gently snap it back in place.

Stop In Today To Get A Backup Key For Your Honda.

Same as the remote you can purchase at your local chevrolet dealership. Insert the new keyfob within 10 sec. For more, check out my other chevy sonic repair & maintenance guides.

You Can See An Example Below.

For more information, click here. Press the small button on the side or back of the key fob while pulling out the side closest to the button. 2) wait 10 seconds and turn key to off and remove.

A Maximum Of 8 Key Transmitters Can Be Programmed.

Insert original key and turn on. Find the small slot on the right side of the driver’s door handle. Insert the mechanical key into this.

This Remote Must Be Professionally Programmed When Received By Your Dealer Or A Local Automotive Locksmith (Click Here For Locksmith Search ).Key Blank Also Needs.

I have replaced my key fob case with a new one i bought from amazon. For chevrolet sonic vehicles equipped with a transponder system and/or remote, intelligent key, or fob key, codes are available. Insert the original, already programmed key in the ignition and turn on the ignition.

Press Any Button On Your Remote For Two Seconds And Wait For The Locks To Click To Indicate Successful Programming Of The Remote And The End Of The Procedure.

Chevy sonic 2014 lt key fob. Conduct the process again for the next key fob remote. The driver information center (dic) displays ready for remote #2, 3, 4, or 5.

Leave a Reply

Your email address will not be published. Required fields are marked *